Ingredients

LIST OF COMPONENTS

  1. Ply wood(ply (4x2 - 3mm) 
  2. Balsa wood (sticks-5mm) 
  3. Thermopol (4x1-2inch ) 
  4. Fuel (methanol) (1-lit)
  5. Paper tape (1)
  6. Steel wire (roll) 
  7. Epoxy 
  8. Boric powder
  9. Paper cutter (2)
  10. Hacksaw Blade (1) 
  11. Cycle wheel rods (12)
  12. Screw driver set (1)
  13. Wood file (1)
  14. Brown sandpaper (2ft)
  15. Inch tap
  16. X-ray paper (2)
  17. Gymsa (3)
  18. German glue (1) 
  19. MiniWax Polyurethane Oil-Based Semi-Gloss (1)
  20. Duct tape (1)
  21. Clear Packaging Tape (1)
  22. Pliers 
  23. Dryer 
  24. Covering sheet (vinyl 4ft x 5ft) 
  25. Fiber cloth (1)
  26. Front transparent glass (Optional)
  27. Wheel (2 inch)
  28. Landing gears (set) 
  29. Push rod (links) 
  30. Spinner (probe)
  31. Engine mount screw (12)
  32. LN key, grabe screw (size no18 - 3mm) 
  33. Control horn (set-tamba) 
  34. Nose gear setting + control horn (set)
  35. Propeller (10x6) (11x6) (2)
  36. Clevis (12)
  37. Fuel tank (1)
  38. Extension lead(34 in) 
  39. V wire (1)
  40. 6 channel transmitter + receiver (2.4 GHz) 
  41. Engine (0.46 cu.in) 
  42. XT60 Connectors Male/Female  (2)
  43. On/off switch (1)
  44. Battery connectors (2) 
  45. Servo motors (5)
  46. Li-po Battery 4.8v (1)
  47. Camelion cell (2700mAh) + charger (1)
  48. Raspberry pi gps (Optional)
Additional Components required for Motor based RC Plane:
  1. Brushless motor (BL 2815) 
  2. ESC 35 Amp (Electronic Speed Control)
  3. Battery (3 lipo cell) 
  4. Li-po charger 
  5. 5 Amp bec (Battery Eliminator Circuit)
Estimated Cost of Motor based RC plane is Rs. 60,000/- PKR
Estimated Cost of Engine based RC plane is Rs. 35,000/- PKR

1 comment:

Subscribe to: Posts (Atom)